_       
( (    /|
|  \  ( |
|   \ | |
| (\ \) |
| | \   |
| )  \  |
|/    )_)
         

 ___   
(  _`\ 
| ( (_)
| |___ 
| (_, )
(____/'
       
       

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
     ##  

 _       _ 
( )  _  ( )
| | ( ) | |
| | | | | |
| (_/ \_) |
`\___x___/'
           
           

     _    
    / \   
   / _ \  
  / ___ \ 
 /_/   \_\
          

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Back MembersPage/NanassyPeter/CloneInstall ----- '''CLT''' Stock Audi Bosch, With default (?) firmware now with AREF=256 reading 7 deg more then real at temp... ---- '''MAT''' Stock VAG Bosch with MAP sensor With default (?) firmware, now reading 7 deg more then real at temp... ,for this clt and iat config. If I understand right (on phone), you've found and successfully tried ( from EasyTherm, hexpatch.exe vems.hex ... of 1.0.36 firmware ) best characteristic curve for your sensor and ECU. Publish any measurements and best-so far curves. * 3000_287 (?) for your ECM with AREF=287 ** should be 3000_256 with v3.x (cloneinstall serial=337 ?) with AREF=256 ---- '''MAT calibration''' I used hexpathc.exe from EasyTherm, it worked fine, then i uploaded the new firmware,and TADA,the IAT now reads only 2deg less then real.I used airden_3000_287 AREF is a resistor (bottom of BuildProcedures/SectionThree) that effects a few readings like battery, MAP, nernstdc and CLT/MAT temperatures (=> different calibration)
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.