### #  
 #   ##  
 #   ##  
  ### #  
      #  
  ####   

         
         
 #####   
 ##  ##  
 ##      
 ##      
 ##      
         

 ___   
(  _`\ 
| (_(_)
`\__ \ 
( )_) |
`\____)
       
       

  ______
 |___  /
    / / 
   / /  
  / /__ 
 /_____|
        
        

         
         
  #####  
 ##      
  ####   
     ##  
 #####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Back to MembersPage/NanassyPeter ----- So finally,after 1 year i decided to install the N75 WGFV,and control it via VEMS. I know from MiskaPeippos page that i have to drive this with a free injector driver.So this will provide the negative voltage,and i should wire the other pin to ignition positive? * Injector driver provides switched GND to N75 valve and in stock wiring harness 12V is provided together with injector supply. How to configure in Megatune? * I have no exactly correct values, but you can try with ones I picked from MembersPage/Fero ** Boost conf=105 Sets PWM period to 6 (*8ms), MAP target active and reference position. ** Actuator off below this pressure=130kPa Defines lowest pressure when boostcontol starts to do something (I think AAN had a bit higher nominal pressure than 0.3bar boost achieved with wastegate spring) * Target offset=0 ** choose correct channel (INJFET and proper channel with not i) ** Set boost vs. rpm and boost vs. TPS tables as you like I have an almost bone stock AAN engine too,what PID settings worked best? * Try with following settings ** boost P=45 ** boost I=27 ** boost D=250 ** PID integral limit=255 thanks,peter ----- After installing the mechanical parts and configured the ECU,i started a LLOOOONNGGG PID tuning session. I educated myself with the help of GRMracer (thanks a lot!). Basially i used the method describer at wikipedia,tried Feros initial Boostconfig,nothing worked.after 2 hours of continous testing,i decided to make a basic test.With only P variable (ID zero) i should have a huge oscillation,while the desired target is beeing overshoot.Now that is what wont happen at all.I cant get more boost than 1 bar (200Kpa) with P only,which makes me wonder,is this really a PID control? Please dont try to tell me what mechanical parts to check,the whole thing is allright,its a pure programming/controlling issue. Every part of the system is STOCK,so no problems here. I also tried to choose the best working PWM period. with the lower (2-8),and only P max(200-255) waiting for oscillation nothing happened (max160-170kpa),and with 15msec perion and 200 P there was a slight oscillaton (200kpa + - 10kpa) Note that the actual target was 230kpa,which was NEVER reached under the whole session. Any suggestions are welcome, i made numerious log (10+). http://www.vems.hu/filethingie.php?action=list&subdir=MembersPage/NanassyPeter/BC_logs I will also try Miskas settings.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.