_____ 
 |_   _|
   | |  
   | |  
  _| |_ 
 |_____|
        
        

 ___   
(  _`\ 
| | ) |
| | | )
| |_) |
(____/'
       
       

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
    ##   
 ####    

   ____  
  / __ \ 
 | |  | |
 | |  | |
 | |__| |
  \____/ 
         
         

 ___   
|  _`\ 
| (_) )
| ,  / 
| |\ \ 
(_) (_)
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Back to MembersPage/NanassyPeter ----- So finally,after 1 year i decided to install the N75 WGFV,and control it via VEMS. I know from MiskaPeippos page that i have to drive this with a free injector driver.So this will provide the negative voltage,and i should wire the other pin to ignition positive? * Injector driver provides switched GND to N75 valve and in stock wiring harness 12V is provided together with injector supply. How to configure in Megatune? * I have no exactly correct values, but you can try with ones I picked from MembersPage/Fero ** Boost conf=105 Sets PWM period to 6 (*8ms), MAP target active and reference position. ** Actuator off below this pressure=130kPa Defines lowest pressure when boostcontol starts to do something (I think AAN had a bit higher nominal pressure than 0.3bar boost achieved with wastegate spring) * Target offset=0 ** choose correct channel (INJFET and proper channel with not i) ** Set boost vs. rpm and boost vs. TPS tables as you like I have an almost bone stock AAN engine too,what PID settings worked best? * Try with following settings ** boost P=45 ** boost I=27 ** boost D=250 ** PID integral limit=255 thanks,peter
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.