______ 
|  _  \
| | | |
| | | |
| |/ / 
|___/  
       
       

  _  __
 | |/ /
 | ' / 
 |  <  
 | . \ 
 |_|\_\
       
       

         
  #### # 
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
     ### 

         
|\     /|
( \   / )
 \ (_) / 
  ) _ (  
 / ( ) \ 
( /   \ )
|/     \|
         

  __  __ 
 |  \/  |
 | \  / |
 | |\/| |
 | |  | |
 |_|  |_|
         
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Back to MembersPage/NanassyPeter Audi A4 20VT 1.8 AEB engine VEMS install in progress * VR 60-2 crank trigger ** missing tooth position ? approx 60deg * HALL camsync ** position (roughly) ? I wont use it * what trigger settings will i need to run totally sequential? ** new branch, 1.0.63 should be best for this. ** tooth_wheel_twidth1=18 (normal tooth width=24) ** normal camsync config, ** h[1]=00 5A 3C 1E .. .. .. .. ** More on config when you have trigger position ok i will go wasted spark i plan to use only 2 IGN outputs, 2 and 3 and wire the coils 1 and 4 to IGN2 2 and 3 to IGN3 ---- '''IAC''' DBW throttle with some idiotic servomotors to control idle (will drop it,and use proper stuff) I will install an oldscool Audi IAC. ---- '''4 COPS''' - negotiation/identification in progress * Beru (this is a 1996 car,not the latest version!) * '''connector, pincount ?''' 3 * '''type, text on the coil?''' * What measurments needed to know COP type ? ** resistance (Ohm, and diode mode voltage drop) between inputs, both direction * logic level (likely) or power level output needed? ** => this determines wiring the COPs? * dwell ? They are power level i already sparked one at the testing phase I need a proper 1.1.18 Megatune, because in the release there is none.I can't mess with the files, PLEASE link a full MT release. ** Download 1.1.23 package and get vemsv3.ini from there, nothing else is needed
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.