_______ 
(_____  )
     /'/'
   /'/'  
 /'/'___ 
(_______)
         
         

______ 
| ___ \
| |_/ /
| ___ \
| |_/ /
\____/ 
       
       

         
  ###    
   ##    
   ##    
   ##    
   ##    
  ####   
         

         
         
  ####   
 ##  ##  
 ######  
 ##      
  #####  
         

         
         
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Back to MembersPage/NanassyPeter Audi A4 20VT 1.8 AEB engine Planning to VEMS it. * VR 60-2 crank trigger ** missing tooth position ? * HALL camsync ** position (roughly) ? * what trigger settings will i need to run totally sequential? ** new branch, 1.0.63 should be best for this. ** tooth_wheel_twidth1=18 (normal tooth width=24) ** normal camsync config, ** h[1]=00 5A 3C 1E .. .. .. .. ** More on config when you have trigger position ---- '''IAC''' DBW throttle with some idiotic servomotors to control idle (will drop it,and use proper stuff) ---- '''4 COPS''' - negotiation/identification in progress * Beru (this is a 1996 car,not the latest version!) * '''connector, pincount ?''' * '''type, text on the coil?''' * What measurments needed to know COP type ? ** resistance (Ohm, and diode mode voltage drop) between inputs, both direction * logic level (likely) or power level output needed? ** => this determines wiring the COPs? * dwell ?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.