___   
|  _`\ 
| (_) )
| ,  / 
| |\ \ 
(_) (_)
       
       

         
         
 # ###   
 ##   #  
 #    #  
 #    #  
 #    #  
         

  _  __
 | |/ /
 | ' / 
 | . \ 
 |_|\_\
       

 _______ 
(  ____ \
| (    \/
| (__    
|  __)   
| (      
| )      
|/       
         

 _   _ 
( ) ( )
| | | |
| | | |
| (_) |
(_____)
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Back to MembersPage/NanassyPeter Audi A4 20VT 1.8 AEM engine Planning to VEMS it. * VR 60-2 crank trigger ** missing tooth position ? * HALL camsync ** position (roughly) ? * what trigger settings will i need to run totally sequential? ** new branch, 1.0.63 should be best for this. ** tooth_wheel_twidth1=18 (normal tooth width=24) ** normal camsync config, ** h[1]=00 5A 3C 1E .. .. .. .. ** More on config when you have trigger position ---- '''IAC''' DBW throttle with some idiotic servomotors to control idle (will drop it,and use proper stuff) ---- '''4 COPS''' - negotiation/identification in progress * Beru (this is a 1996 car,not the latest version!) * '''connector, pincount ?''' * '''type, text on the coil?''' * What measurments needed to know COP type ? ** resistance (Ohm, and diode mode voltage drop) between inputs, both direction * logic level (likely) or power level output needed? ** => this determines wiring the COPs? * dwell ?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.