### ## 
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

 _   _ 
| | | |
| |_| |
|  _  |
| | | |
\_| |_/
       
       

         
         
  ####   
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
         

         
         
  ####   
 #    #  
 #       
 #    #  
  ####   
         

         
         
  ####   
 ##      
 ##      
 ##      
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Mercedes M119''' V8 5L naturally aspirated * '''300 kPa MAP''' sensor, simplenipple * manual throttle * '''8 IGBT''' ---- '''Ignition''' '''8 passive coils''' * 4 stepper + 4 logiclevel ign output ---- '''VR-VR''' * '''primtrig VR''': crank 60-2 * '''sectrig VR''': camshaft ---- '''2 NFETs for On-off''' intake cam (2 actuators, but controlled by same on-off signal, no need for separate feedback like PWM VANOS/VVTI). '''12V, controlled by NFET (low-side switch)''' * EC36/3 but controlled by extrafet (7.5 Ohm) * EC36/15 but controlled by extrafet (7.5 Ohm) ---- '''TPS''' - big Electronically controlled ("DBW") block with 2+14 wires (but some wires are actually empty, mostly the tan-brown insulator-tubes; weird). Mechanically modified so manual throttle bowden can almost full open it (without the aid of the electric motor). * TPS signal: '''red-white''' (appr. 0.55k .. 1.4k resistance measured: when opening throttle: resistance growing towards red-grey ; resistance falling towards black-grey) * GND: '''red-grey''' * +5V: '''black-grey''' Mercedes (W140) M119 500 throttle wires * idle OFF/ON signal: between '''white-brown and white-green''' ** open at idle, 0.33k above idle ---- '''Idle: currently mechanically raised idle'''. * optionally: Opel 1 wire idle valve ---- BT (2nd RS232 optional) TODO: * test mc7 oil temperature C gauge on VemsDisplay (triggerframe mode) * test EGT exhaust temperature C gauge on VemsDisplay (triggerframe mode) ---- * 1 x '''LSU4.9''' + connector * no EGT. ----
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.