_    _ 
 | |  | |
 | |  | |
 | |  | |
 | |__| |
  \____/ 
         
         

         
         
  ### #  
 #   ##  
 #   ##  
  ### #  
      #  
  ####   

  _   _ 
 | | | |
 | |_| |
 |  _  |
 |_| |_|
        

         
         
  ####   
 #    #  
 #    #  
 #    #  
  ####   
         

         
         
 #    #  
 #    #  
 #    #  
 #   ##  
  ### #  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Peppes E30 BMW with M20 turbo engine: \ MembersPage/MattiasSandgren/PeppesBmw Magnus E23 BMW with M30 turbo engine: \ MembersPage/MattiasSandgren/BmwSevenTwentyEight Another Magnus, Volvo PV with turbo engine: \ MembersPage/MattiasSandgren/VolvoPV Fredrik Eriksson BMW 535 Twin Turbo: \ MembersPage/MattiasSandgren/BmwTwinTurbo My cars: MembersPage/MattiasSandgren/BmwEthirtyIx MembersPage/MattiasSandgren/VolvoHundredFortyTwo ---- '''2 x Hall on Genboard v3.2''' I'm setting up two v3.2 Genboards with primary and secondary triggers configured for a Hall sensor input. I've gone by advice from Emil and Jörgen here, which conflicts with what is recommended : GenBoard/Manual/InputTriggerHardWare * Bottom view [http://www.vems.hu/files/MembersPage/MattiasSandgren/Trigger/hall_v3.2_bottom_view.jpg Picture of trigger area] ** I've added 1n capacitors between ground and each trigger signal. I've shorted SJ5 in this picture. * Top view [http://www.vems.hu/files/MembersPage/MattiasSandgren/Trigger/hall_v3.2_top_view.jpg Picture of trigger area] ** The jumpers are in place for the trigger signals, they might be replaced by solder jumpers in the future if I have issues - the jumpers won't budge easily. I've shorted SJ2 in this picture. I've also removed the resistor next to SJ2 which I did after the picture was taken. There are two pull-up resistors (103) near the jumpers, if there are problems I might replace them with smaller (102). You should move this info to GenBoard/Manual/InputTriggerHardWare when you have a working solution. ----
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.