#####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

         
         
 ######  
    ##   
   ##    
  ##     
 ######  
         

###      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
######   
         

 _    _ 
( )  ( )
`\`\/'/'
  >  <  
 /'/\`\ 
(_)  (_)
        
        

         
         
 ##  ##  
  ####   
   ##    
  ####   
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Peppes E30 BMW with M20 turbo engine: \ MembersPage/MattiasSandgren/PeppesBmw Magnus E23 BMW with M30 turbo engine: \ MembersPage/MattiasSandgren/BmwSevenTwentyEight Another Magnus, Volvo PV with turbo engine: \ MembersPage/MattiasSandgren/VolvoPV Fredrik Eriksson BMW 535 Twin Turbo: \ MembersPage/MattiasSandgren/BmwTwinTurbo My cars: MembersPage/MattiasSandgren/BmwEthirtyIx MembersPage/MattiasSandgren/VolvoHundredFortyTwo ---- '''2 x Hall on Genboard v3.2''' I'm setting up two v3.2 Genboards with primary and secondary triggers configured for a Hall sensor input. I've gone by advice from Emil and Jörgen here, which conflicts with what is recommended : GenBoard/Manual/InputTriggerHardWare * Bottom view [http://www.vems.hu/files/MembersPage/MattiasSandgren/Trigger/hall_v3.2_bottom_view.jpg Picture of trigger area] ** I've added 1n capacitors between ground and each trigger signal. I've shorted SJ5 in this picture. * Top view [http://www.vems.hu/files/MembersPage/MattiasSandgren/Trigger/hall_v3.2_top_view.jpg Picture of trigger area] ** The jumpers are in place for the trigger signals, they might be replaced by solder jumpers in the future if I have issues - the jumpers won't budge easily. I've shorted SJ2 in this picture. I've also removed the resistor next to SJ2 which I did after the picture was taken. There are two pull-up resistors (103) near the jumpers, if there are problems I might replace them with smaller (102). ----
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.