###    
   ##    
   ##    
   ##    
   ##    
  ####   
         

     _    
    / \   
   / _ \  
  / ___ \ 
 /_/   \_\
          

         
 ####### 
 ##  ##  
    ##   
   ##    
  ##  ## 
 ####### 
         

  ____  
 | __ ) 
 |  _ \ 
 | |_) |
 |____/ 
        

 __        __
 \ \      / /
  \ \ /\ / / 
   \ V  V /  
    \_/\_/   
             

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Status''' '''2005-05-28''' I've made MegaTune files for 15x15 and I'm going to try them out today. I've bench-tested and all seems good. Here is the file I'm using: [http://www.vems.hu/files/MembersPage/MattiasSandgren/VolvoPV/vemsv3_15x15.ini vemsv3_15x15.ini] ---- '''Information about the installation''' Emil Larsson made the initial install: Genboard serial no: 204, with pump_zero_pw=0x65 Firmware wishes, more or less needed for this car. * Exhaust backpressure input * both EGT channels on LCD, best would be with current and max reading * Extra temperature inputs, most important is for automatic transmission temp * EGT based enrichment (if egt goes over a configured value, start adding more fuel to cool.. With the automatic transmission, the engine goes on full load for the full quarter mile, more fuel is needed to keep the engine from detonating, currently tuned to run too rich off the line) * Cold engine ignition retard, Maybe not too important with the adv. based idle control. * Some sort of check engine light/warning light, configurable for different temperatures and pressures, also when trigger/camsync problems appear, maybe with one led that says "hey, check your LCD", and one huge lamp / loud summer that says "switch off now, somethings is blowing" This car is using a MSD 6 ignition system and distributor. * Engine spec. ** 4 cyl B23 block ** Marine 2.3L 16V volvo head ** Custom made cam shafts * H-profile aftermarket rods * A big Schwitzer turbo with an advanced manifold and wastegate system [http://savarturbo.se/images/bilarna/soder/info/volvo_pv_pic05_hood_off.jpg Picture of engine bay] *Trigger setup: ** Main trigger is a pulley on the crankshaft, aluminium with 2 8mm (square or round), 8mm high iron pieces, to trig a Honeywell GT1 sensor. ** Cam trigger is not implemented yet, but will be easy. Change one of the M8 bolts on the adjustable camsprocket to a longer one, a GT1 will be used here too. http://img.photobucket.com/albums/v133/irocz/hosttavlingen%20pite/pite8.jpg
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.