###      
 ## ###  
 ## #    
 #####   
 ## ##   
 ##  ##  
#### ### 
         

   _____ 
  / ____|
 | (___  
  \___ \ 
  ____) |
 |_____/ 
         
         

         
         
 ##  ##  
  ####   
   ##    
  ####   
 ##  ##  
         

  _    _ 
 | |  | |
 | |  | |
 | |  | |
 | |__| |
  \____/ 
         
         

_________
\__   __/
   ) (   
   | |   
   | |   
   | |   
   | |   
   )_(   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Peter Högdahls BMW 1602''' http://www.vems.hu/files/MembersPage/MattiasSandgren/PeterBMW/peter_bmw_1602_launch.jpg '''Configuration''' Peter is running 1.0.73 and is using the BMW dual solenoid ICV. More tweaking to the ICV settings could be done, but works satisfactory for him. Here are the files: \\ [http://www.vems.hu/files/MembersPage/MattiasSandgren/PeterBMW/config.txt config.txt] \\ [http://www.vems.hu/files/MembersPage/MattiasSandgren/PeterBMW/tables.txt tables.txt] \\ [http://www.vems.hu/files/MembersPage/MattiasSandgren/PeterBMW/megasquirt200708021458_KLAR_720cc.msq msq file] '''VEMS Genboard specification''' 1-wire interface: No \\ ignition driver: 8 \\ Knock and EGT: Knock and 2 EGT \\ LCD and PS2: Yes \\ MAP connection: 400 kPa on-board (6/4 mm pneumatic) \\ mounting-style: no screws \\ PowerFlyback: No \\ primary_trigger: Hall \\ secondary_trigger: Hall '''Engine specification''' * BMW M10, 2.0 litre crank, stock rods and Mahle forged pistons * Schrick "304 degree" cam shaft * 800 cc low-Z injectors * MSD Blaster 2 coil and MSD 7A CDI-box * Primary trigger is simple type, Honeywell GT1 Hall-sensor on crank with pssible future upgrade with Hall type cam sync * Large turbo (HX50), large intercooler, lots of boost. '''Engine harness''' The harness has been built so that you can remove it all and take the engine to an engine dyno. Looks very promising, but one should expect this from a professional electrician like Peter: http://savarturbo.se/images/bilarna/peter/garage_2007/vems_harness_installed.jpg ''' Trigger setup''' Two thick pieces of metal pass by the Hall sensor at 45-50 before TDC. Should be quite fool-proof. http://savarturbo.se/images/bilarna/peter/garage_2007/trigger_setup.jpg
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.