___   
(  _`\ 
| ( (_)
| |  _ 
| (_( )
(____/'
       
       

         
 ##      
 ##      
 ## ##   
 ####    
 ## ##   
 ##  ##  
         

         
         
 ##   ## 
 ## # ## 
 ####### 
 ####### 
  ## ##  
         

         
         
 ##   ## 
 ## # ## 
 ####### 
  #####  
  ## ##  
         

 ___   
(  _`\ 
| |_) )
| ,__/'
| |    
(_)    
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Nicke Nymans Volvo 242''' ---- '''Engine specifications''' * Volvo B21ET ** 4 cyl, OHC, 2 valves/cyl ** Stock B21ET bottom end * Volvo V cam (279 degrees @ 0.51 mm, 11.37 mm valve lift) * Custom intake plenum and 65 mm throttlebody * Low impedance 900 cc/min injectors used with 6.8Ohm/50W resistors and a30 V TS diode on the flyback wire * COPs from an Audi S4 * Long tubular turbo exhaust manifold * Holset HX35 turbo, 55 in/60 out with 12 cm² exhaust housing. * Large front mount intercooler * Primary trigger consists of two metal points for simple trigger using Honeywell GT1 Hall-sensor, signal goes low 60 degrees before TDC. * Secondary trigger is a lobe on the balance axel found in these engines, same rotational speed as the cam. Signal goes low after cyl 4 TDC and high again before TDC + 90 deg. ** The lobe was originally made for driving a mechanical pump ** The lobe has been shaped to be 10 mm wide and ends abruptly to get a good metal piece for the sensor ---- '''Pictures''' http://attitude.mine.nu/bilder/TurboNicke/New%20project/Mattias%20bilder/bil2.jpg http://attitude.mine.nu/bilder/TurboNicke/New%20project/Mattias%20bilder/motorrum1.jpg
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.