###    
     #   
  ####   
 #   #   
  ### #  
         

______ 
|  ___|
| |_   
|  _|  
| |    
\_|    
       
       

 _______ 
(  ___  )
| (   ) |
| |   | |
| |   | |
| |   | |
| (___) |
(_______)
         

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

 _______ 
(  ____ \
| (    \/
| (_____ 
(_____  )
      ) |
/\____) |
\_______)
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Nicke Nymans BMW E21 M20 Turbo''' [http://savarturbo.se/stuff/images/nicke_e21_tic/PICT0884.JPG Picture] ---- A page about how I fixed the missing boot loader after we replaced the AVR (why? long story) : MembersPage/MattiasSandgren/NickesBMW/AvrBootCode ---- '''Genboard specific configuration''' This is a v3.2 with production number 127. Both triggers are configured for Hall. Ignition outputs ||00||IGBT (Currently used to drive an MSD 6A)|| ||01||IGBT|| ||02||IGBT|| ||03||IGBT|| ||04|| SDA (PD1) - on JP1 connector (current default for AntiLagSystem)|| ||05|| SCL (PD0) - on JP1 connector || ||06||IGBT|| ||07||Ground for SCL and SDA || EGT - only first input used. LCD and PS2 - are brought through a DSUB25 as described here : GenBoard/BuildProcedures/LCDconnect MAP - MPX4250AP 250kPa=2.5 bar (1.5 bar boost) using a push-in connector in the front plate. Injector driver flyback - GenBoard/Manual/PowerFlyback '''Q''': Is [http://www.vems.hu/files/MembersPage/MattiasSandgren/sda_scl_wired_to_igbt_pins.jpg this] wiring method for SDA and SCL signals a stupid move? I'm thinking of running by the IGBTs in use. Currenly only one ('00'). * should work, but ** why not shorter traces, at the endplate side of the board (instead of the econoseal - frontplate - side) ? ** secure the wires with hotmelt, to avoid breaking due to vibration What is the brownish (slightly burnt?) GND5 at the non-used IGBT position at the lower right corner ?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.