#####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

         
         
 # ###   
 ##   #  
 #    #  
 #    #  
 #    #  
         

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
     ##  

    #    
         
   ##    
    #    
    #    
    #    
   ###   
         

 _   __
| | / /
| |/ / 
|    \ 
| |\  \
\_| \_/
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
|| [http://www.vems.hu/wiki/index.php?page=MembersPage%2FMattiasSandgren%2FMrideCarForTwo Start] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FMattiasSandgren%2FMrideCarForTwo/Trigger Trigger] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FMattiasSandgren%2FMrideCarForTwo/FuelInjection FuelInjection] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FMattiasSandgren%2FMrideCarForTwo/Display Display] || [http://www.vems.hu/wiki/index.php?page=MembersPage%2FMattiasSandgren%2FMrideCarForTwo/Wiring Wiring] || ''' Wiring''' ''More pictures will be added'' ---- Grounds * Grounds (1 mm²) are connected to the chassis about 40 cm from the harness connectors. * The small 14 Ah battery has it's ground connected to the engine block. * Signal grounds and serial communication is grounded close to pin 26. ---- Fuses * 7.5 A, injectors * 1 A, VEMS Genboard and fuel pump relay coil pin 86 * 5 A, wide band sensor heater * 10 A, fuel pump ---- Relays * Only one fuel pump relay, grounded through P259-5 (EC36-15) with protection diode ---- Connectors * All injectors and sensors are removeable from the harness with sealed connectors from the web shop ---- LCD display * Mounted up front right in the driver cock pit * 1.5 meter shielded serial cable was used, we have seen zero errors/problems ---- Alubos mounting * Mounted on edge, connectors face rear of the vehicle * Dampening material between the box and mounting surface * Pre-built was good, but extra hot melt glue has been added to support MAP sensor and other throughole components Great care has be taken to make this installation safe from vibration since this is a vehicle with stiff suspension and bushings, and a very high rpm engine. http://www.vems.hu/files/MembersPage/MattiasSandgren/MrideCarForTwo/vems_placement.jpg
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.