###    
   ##    
   ##    
   ##    
   ##    
   ##    
  ####   
         

           
     /\    
    /  \   
   / /\ \  
  / ____ \ 
 /_/    \_\
           
           

         
         
  #####  
 ##      
  ####   
     ##  
 #####   
         

         
|\     /|
| )   ( |
| (___) |
|  ___  |
| (   ) |
| )   ( |
|/     \|
         

         
### ###  
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  ### ## 
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I'm helping a guy via phone/e-mail to calibrate the wideband sensor with his ECU. He input the correct values from the paper he received with the ECU (#2909) which according to him are 101/134. There is 0.31 Volts between pin 5&6 of the WBO2 connector. The sensor then needed a value of 141 to calibrate correctly, this is lower than what I usually find (180-200). Would a '''wrongly set wbo2_pump_pw_zero''' cause the sensor calibration value to be so far off from normal? I will ask the customer to try different values for wbo2_pump_pw_zero, between 98-105, and see if he can get pin 5&6 to read closer to 0 Volts.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.