####   
 ##  ##  
 ######  
 ##      
  #####  
         

         
         
  #####  
 ##      
  #####  
      ## 
 ######  
         

         
 ##      
 ##      
 ## ##   
 ####    
 ## ##   
 ##  ##  
         

         
### ###  
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  ### ## 
         

 ______  
(  ___ \ 
| (   ) )
| (__/ / 
|  __ (  
| (  \ \ 
| )___) )
|/ \___/ 
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
(This page will eventually move to it's owners MembersPage.) Fredrik Eriksson contacted me about setting up VEMS on his BMW 535 (E28) on which he has a twin turbo setup. More information here (in Swedish): http://www.535twinturbo.com/ He previously ran with SMT6 but found it couldn't handle the engine and requirements and has decided to get an assembled VEMS/Genboard. '''Engine information''' * Mostly stock M30B35, a 3.5 litre 6 cylinder even-fire inline (not odd-fire V6) engine with ~210 hp N/A with stock engine management * 2 x Garret T3 from Saab NG900/OG93 * Custom exhaust manifolds * 2 x EGT K-type thermocouples in the collectors * 6 x 380 cc/min high impedance injectors * Single coil and distributor (for initial setup, direct-fire setup might come later) '''Trigger setup''' The stock reference and speed sensor are NOT usable with VEMS as far as I know, these are mounted at the back of the engine. * One measure engine speed through 360 teeth '''crank or cam mounted? (VR or HALL/optical ?)''' * the other syncs with the engine once every revolution. So it's kind of like a missing tooth setup - only it isn't. The solution that will be used: Three M8 bolts will be fastened to the harmonic dampener at the front of the engine, 120 degrees apart with 8 mm protrusion. A Honeywell GT1 Hall sensor will be used to sense these. '''Assembled v3.2 controller wishes''' * '''both primary and secondary trigger inputs should be of HALL type'''. * MPX4250AP 255kPa MAP sensor mounted onboard, with frontplate mounted pneumatic connector. * Serial RS232 and LCD through front endplate. * PS2 through EC18. '''(Is this even possible? Pinout doesn't agree - was flying loom through rear endplate intended?)''' * 2 x AD597 chips (normally they have to be added to the order and mounting is free ... but don't worry about it, we'll add and mount them) ** 2 x compensational cables through the frontplate, flying loom style ** 2 x K-type female chassis connectors will be mounted by Fredrik
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.