####   
     ##  
  #####  
 ##  ##  
  #####  
         

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

 _       
| \    /\
|  \  / /
|  (_/ / 
|   _ (  
|  ( \ \ 
|  /  \ \
|_/    \/
         

         
         
 ##  ##  
 ####### 
 ## # ## 
 ##   ## 
 ##   ## 
         

         
         
 #    #  
 #    #  
 #    #  
  #  #   
   ##    
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
A customer has a 3B Pnp (board v3.7 # 6651) and wants to run 60-2 Hall for the primary trigger. Some easy steps I've done : * Enabled Hall primary trigger : SJ2 closed, SJ6 open, R30 2.7k * Disconnect LM1815pin12 output from the microcontroller input pin : Removed SJ7 solder-blob on the bottom ** Should be enough according to GenBoard/Manual/InputTriggerHardWare : '''Yes, confirmed.''' * '''already has the HALL part of the circuit set up from EC36/13)''' * What about the transistor, yellow wire, and heat shrinked through-hole resistor ? ** It does not matter if sectrig HALL is inverted or not (since '''falling or rising edge''' can be selected in secondary trigger dialog configuration). So if LM1815 output is disconneted, the processor will see the HALL signal [http://www.vems.hu/files/MembersPage/MattiasSandgren/AudiPnp/audi-3b-hall-hall.jpg Image of trigger component area]
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.