_    _ 
( )  ( )
`\`\/'/'
  >  <  
 /'/\`\ 
(_)  (_)
        
        

         
         
 ##   ## 
 ## # ## 
 ####### 
 ####### 
  ## ##  
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
    ##   
 ####    

   ##    
   ##    
  #####  
   ##    
   ##    
   ## ## 
    ###  
         

__   __
\ \ / /
 \ V / 
  \ /  
  | |  
  \_/  
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
A customer has a 3B Pnp (board v3.7 # 6651) and wants to run 60-2 Hall for the primary trigger. Some easy steps I've done : * Enabled Hall primary trigger : SJ2 closed, SJ6 open, R30 2.7k * Disconnect LM1815pin12 output from the microcontroller input pin : Removed SJ7 solder-blob on the bottom According to [http://www.vems.hu/wiki/index.php?page=GenBoard%2FManual%2FInputTriggerHardWare wiki link] this should be enough. * ''actually this is the only step required if converting from sectrig=auditrigger (because that already has the HALL part of the circuit set up from EC36/13)'' * What about the transistor, yellow wire, and heat shrinked through-hole resistor ? [http://www.vems.hu/files/MembersPage/MattiasSandgren/AudiPnp/audi-3b-hall-hall.jpg Image of trigger component area]
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.