_   _ 
 | | | |
 | |_| |
 |  _  |
 |_| |_|
        

 _______ 
(  ___  )
| (   ) |
| |   | |
| |   | |
| | /\| |
| (_\ \ |
(____\/_)
         

         
  ###    
   ##    
   ##    
   ##    
   ##    
  ####   
         

         
         
  ###### 
 ##  ##  
 ##  ##  
  #####  
     ##  
    #### 

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
=== Audi trigger 1.2.16 "hickup" === A customer with a Audi pnp unit has run for a couple of years with various firmwares and the way the car runs and behaves has steadily improved with tuning and better firmware features. With an early release of 1.2.16 the car suddenly developed a strange mis-fire, or ignition miss, trigger miss, or whatever you can call it. Datalogs say nothing, except show that : * the engine looses a few revolutions and usually catches up * it can die sitting still in traffic at idle * it exhibits no problems at high engine load/rpm Now with a later release of 1.2.16, the TPS signal reads 0% at high rpm/load and the engine cuts out. === Reverting back to 1.2.11 and it runs normal again. === * Early 1.2.16 datalog[http://www.vems.hu/files/MembersPage/MattiasSandgren/vemslog/v3.3_u006194-2013.10.14-18.38.16.vemslog vemslog] ** Slight misses at idle visible in datalog * Later 1.2.16 (23 september) release [http://www.vems.hu/files/MembersPage/MattiasSandgren/vemslog/v3.3_u006194-2013.10.17-18.16.50.vemslog vemslog] ** TPS reads 0% and engine cuts out. Can you tell from the configuration of the ECU that something causes this? Suggestions in error_report_center - DB What should we do ? Increase to something more than divby3 for the trigger? === Engine configuration === * Stock AAN hardware * Siemens fuel injectors 875 cc * VAG 115 coils Other 115 coils have been tested to see if that was the problem before it was discovered that it ran fine with a slightly less recent firmware, and then the TPS reading problem with the latest.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.