#### ## ##### ## ## #####
###### ## ## ## ## ## ## ## ## ## ## ## ## ## ## ##
_____ / ____| | | | | | |____ \_____|
______ | ___ \ | |_/ / | / | |\ \ \_| \_|
### ##### ## ## ## ## ## ## ## ## ### ##
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: Writing this on behalf of Marko ---- 17.08.2006 Car-opel astra 2.0 16v Turbo gt2876r garret turbo vems3.3 680cc injectors tial wg Personal VEMS is on the way back so currently using Kuuno's vems wich has exactly the same hardware as mine! We are receiving the same problem as on the Hyundai-rpm is below 200 while cranking and drops off after every few seconds and then comes back. Soemtimes also trigger error occurs! * describe setup (wiring, especially trigger, inj and ign) ** preferrably capture logs too * config and firmware info as on IssueReports * take InputTrigger/TriggerLog so we know polarity: might easily be the problem. no spark from the ignition coils... Trigger wheel is also 60-2. Will try to make a picture of the signal at missing tooth tomorrow! ---- meanwhile vems travelled to marcell and is back now! Thanks Marcell! Car started up today but did not havce time to tune yet. VE is pretty rich and maybe some trigger errors also as engine was stumbling but will look into it tomorrow... (vems firmware was 1.0.38) ---- I took some time to tune the car(from 2 at night to 6 in the morning :D ) it is configured to 1.6 bar and mixture is around 12-12.5 ignition is 9 at lowest(4500rpm and up@1,2bar and over) measured with gtech best time was 13.7 and best 0-100 around 5.9 but it was wet road :) anyway vems acts as needed again! :) Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.