_ 
(_)
| |
| |
| |
(_)
   
   

    ###  
   ##    
   ##    
 ######  
   ##    
   ##    
   ##    
         

         
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

         
         
 ######  
  ##  ## 
  ##     
  ##     
 ####    
         

         
         
  ####   
 ##  ##  
 ##      
 ##  ##  
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Subpage of ((MembersPage/MarcelBMW_M50B25_Turbo)) Please '''provide a wiring list''' (must always be present, wether universal harness or made from scratch, since impossible to do the essential verification measurements without them anyway) * outputs * injector shared + (flyback EC36/23) * grounds * inputs ---- '''Grounds: list those connected, and do the measurement with breaklight as a load''' * With '''ECU disconnected, please use a 2A (25W) brake-light bulb to flow current''' and measure voltage drop (should be <30mV) ** '''VEMS ECU has extremely strong injector and ignition outputs (10A capable) wether the engine is running or not.''' ** If the ECU cannot activate some of those outputs while engine is running, it is almost always related to wiring (eg. grounding) problem. ---- '''Outputs - please complete: list ALL connected outputs ''' * Stepper - A : Vanos (solenoid resistance: ... Ohm, - side) * ignch2 : fuelpump (relay, - side) * ... ---- * is it possible to see the measurement notes related to ground and flyback measurements ? ** or do the measurements now and take notes ? ** Ohm measurements, with ECU disconnected. For ground wires, mV measurement would be superior, with 2A flowing through (eg. break-light bulb or 25W bulb would be awesome, <30mV drop over any wire + connector pin) https://www.bilder-upload.eu/bild-4c8044-1579209910.jpg.html Measurements i have already done on all Grounds and the + connections. Grounds = exact same everywhere Measured from pin to chassis and from pin to pin (ohm of course) Dont forget please that every output works if the Engine dont run. '''When the Engine runs it does not send Ground to the relay for fan and fuelpump. ''' Changed the output already and problem still exists. * '''VEMS ECU has extremely strong injector and ignition outputs (10A capable) wether the engine is running or not.''' ** If the ECU cannot activate some of those outputs while engine is running, it is almost always related to wiring (eg. grounding) problem. Measuring woth lightbulbs and special Measuretools not easy in my garage because i only have a multimeter and 1 battery. * yes, but '''it is likely to help''' (hopefully that will give some motivation...) ** On the countrary, sending the ECU anywhere in case of similar symptoms is unlikely to help, because with such symptoms the harness must be verified first, really. Also, upload some photos. See FileArea
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.