######  
  ##  ## 
  ##     
  ##     
 ####    
         

 __   __
 \ \ / /
  \ V / 
   | |  
   |_|  
        

 ___   
|  _`\ 
| (_) )
| ,  / 
| |\ \ 
(_) (_)
       
       

         
         
  #####  
 ##      
  ####   
     ##  
 #####   
         

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
     ##  

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Can't get my Genboard v2.2 working... Using Marcell's programming instructions from: http://www.x-dsl.hu/genboard/programmer.txt Currently my cable is wired as an STK200: <code> Header AVR LPT ------ --- --- 1 PDO 10 2 VCC n/c 3 SCK 6 4 PDI 7 5 RESET 9 6 Ground 21-25 </code> AVRDude reports: ---- <code> C:\WinAVR>avrdude -c stk200 -p m128 -F avrdude: AVR device not responding avrdude: initialization failed, rc=-1 avrdude: AVR device initialized and ready to accept instructions Reading | ################################################## | 100% 0.00s avrdude: Device signature = 0xffffff avrdude: Yikes! Invalid device signature. avrdude: safemode: Fuses OK avrdude done. Thank you. C:\WinAVR> </code> ---- What I've checked: - Installed giveio.sys, service started - ISP pins to pins on AVR - VCC/GND to AVR - Clock signal on XTAL pins What's next? I can scope it if necessary, just don't know what I'm looking for...
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.