####  
  ## #   
  ##     
 #####   
  ##     
  ##     
 ####    
         

         
         
 #####   
 ##  ##  
 ##      
 ##      
 ##      
         

         
         
  ####   
 ##  ##  
 ##      
 ##  ##  
  ####   
         

         
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

         
         
  ####   
 ##  ##  
 ######  
 ##      
  #####  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Can't get my Genboard v2.2 working... Using Marcell's programming instructions from: http://www.x-dsl.hu/genboard/programmer.txt Currently my cable is wired as an STK200: <code> Header AVR LPT ------ --- --- 1 PDO 10 2 VCC n/c 3 SCK 6 4 PDI 7 5 RESET 9 6 Ground 21-25 </code> AVRDude reports: <code> C:\WinAVR>avrdude -c stk200 -p m128 -F avrdude: AVR device not responding avrdude: initialization failed, rc=-1 avrdude: AVR device initialized and ready to accept instructions Reading | ################################################## | 100% 0.00s avrdude: Device signature = 0xffffff avrdude: Yikes! Invalid device signature. avrdude: safemode: Fuses OK avrdude done. Thank you. C:\WinAVR> </code> What I've checked: - ISP pins to pins on AVR: GOOD - VCC/GND to AVR: GOOD - Clock signal on XTAL pins: GOOD What's next?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.