##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
         

         
         
 #####   
 ##  ##  
 ##      
 ##      
 ##      
         

         
         
  ### #  
 #   ##  
 #   ##  
  ### #  
      #  
  ####   

         
         
  ###    
     #   
  ####   
 #   #   
  ### #  
         

         
         
 ######  
    ##   
   ##    
  ##     
 ######  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''installing VEMS V3 on BMW engine M73B54''' I'm using '''crankshaft sensor VR with 60-2 tooth''' and waste-spark ignition I have '''issue with the crankshaft sensor. During cranking I can't see any readings from the sensor'''. * What is DC voltage measured on EC36/pin27 ? * I test the sensor with othere electronicks and it is ok. What setup do I need to make to the ECU? I directly connect the sensor to the VEMS on PINs 26 (GND) and 27 (VR +). I test it in both directions (I swap the two wires on pin 26 and 27) and no improvement. * seems OK, but read on ---- '''Ground connections ?''' * GenBoard/Manual/GroundConnections P259 outputs are OK ? * sometimes insufficient GND kills p259, which prevents LM1815 +5V (symptom is no trigger pulses seen) ** in that case fix harness GND, remove or replace p259 ---- See also MembersPage/MSeventyThreeVeeTwelve ---- Hi, I'm wiring the engine and the ECU (testing the connections). I connect GND on pins 5 and 32 directly to the batt. I'm reading TPS via VEMS software on laptop, but I'm not seeng any readings from the VR sensor (during crancing). I don't connect anything to p259 yet, I will conect fuel relay on pin 15. Can you give some recommendations for the configuring the ECU (to this moment I didn't make any adjustment of the ECU). Maybe that is the reason behind that I'm not seeing any data from the VR sensor. Thanks in advance Br.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.