_______ ( ____ ) | ( )| | (____)| | _____) | ( | ) |/
##### ## ## ## ## ## ## ## ##
___ | _`\ | (_) ) | , / | |\ \ (_) (_)
|\ /| | ) ( | | | _ | | | |( )| | | || || | | () () | (_______)
_ _ | \ | | | \| | | . ` | | |\ | \_| \_/
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: ---- '''Navigation''' * Main MembersPage/KoabiBrooks * Ignition MembersPage/KoabiBrooks/Ignition * Injection MembersPage/KoabiBrooks/Injection * Trigger MembersPage/KoabiBrooks/Trigger * Wiring MembersPage/KoabiBrooks/Wiring * Q&A MembersPage/KoabiBrooks/Questions ---- '''MAIN PAGE''' http://www.starshadow.com/~koabi/photos/sciroccoproject/051224sciroccoengine.jpg I have an '88 Volkswagen Scirocco '''My goals''' *To have control over engine management *Make car reliable (near stock levels?) *Learn about what makes all these variables work together *NOT TO BLOW UP THE MOTOR '''Car Specs''' *Suspension **Eibach Sportline Springs **Tokico Shocks and Struts (for now) **Poly bushings *Engine **ABA 2.0l 4 cylinder motor (From OBDI Jetta or Golf) **PL 16v head (From 1.8l 16v Scirocco) **Thottlebody with TPS (From automatic Corrado - bolts on) **Turbo T3 .60/.48 (From ~'84 Ford Thunderbird) **Gillis boost controller (Manual screw type) **Intercooler **Fuel Injection from G60 Corrado (CURRENTLY) **48# high z injectors (correct if wrong - high z meaning constant voltage to open is what I am assuming) *Transmission **Stock time-bomb ---- '''VEMS SETUP''' I am going with v3.3 assembled. Here is the current plans, which are subject to many, many changes. '''Planned components''' *Sensors **Intake Air Temperature (IAT) ***GM #25036751 **Manifold Absolute Pressure Sensor (MAP) ***2.5 bar (on board ECM) **1 Wideband oxygen sensor (WB02) ***Bosch LSU4 **1 knock sensor (engine can accept 2, so perhaps I will eventually use 2) **Exhaust Gas Temperature sensor (EGT) ***K Type **Throttle Position Sensor (TPS) ***From automatic Corrado **Fuel Pressure Sender ***Probably the one at the VEMS webstore **Boost Controller ***Also through the VEMS webstore '''Ignition and Injection Setup''' *Crank trigger from ABA code motor - I won't be using a Hall ** VR std 60-2 VAG wheel on ABA crank. Those using different blocks may have to use external setups. See MembersPage/DerrickScirocco ***Part # 021 907 319 B *Wasted Spark Ignition **4 output coilpack from 99 2.0 8v VW - new beetle for sure, AEG engine code (this way I can use my stock plug wires) ***Part # 032 905 106 B *Sequential Fuel Injection (apparently it's an easy change toggling batch -> sequential, as long as you have the injectors wired separately) ---- '''CURRENT STATUS''' AREF / AVCC mod being applied to ECU ---- '''Useful Resources''' Crank wheel trigger generator: http://www.starshadow.com/~koabi/carstuff/cranktriggers.php GrmRacer's install guide (note injector flyback is accidentally omitted from the pinout): http://www.starshadow.com/~koabi/carstuff/VEMS/Information%20to%20setup%20your%20VEMSv3.htm ---- '''Comments''' MembersPage/PhatBob - Hi, we're loving that tooth generator php app! One of the guys found: http://www.starshadow.com/~koabi/carstuff/VEMS/Information%20to%20setup%20your%20VEMSv3.htm on your site, so that it doesn't cover the same ground as: http://www.vems.hu/wiki/index.php?page=MembersPage%2FPhatBob%2FUserGuide Do you want to work together on incorporating the texts together and developing a guide? I like the CD idea, and am currently working on one for the Round wideband. PhatBob: GrmRacer ( MembersPage/GrmRacer ) actually kindly did the installation document. You should talk to him about combining the guides - sounds like it could end up being a good community resource. Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.