_   _ 
( ) ( )
| `\| |
| , ` |
| |`\ |
(_) (_)
       
       

  _____
 |__  /
   / / 
  / /_ 
 /____|
       

         
         
  ####   
 ##      
 ##      
 ##      
  ####   
         

  ____  
 | __ ) 
 |  _ \ 
 | |_) |
 |____/ 
        

         
##  # ## 
##  #  # 
 ## ## # 
 ### ##  
  ## ##  
  #   #  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Kevin Black, Northeast USA. I am interested in helping develop the VEMS and selling to the VW/Audi market. Contact: Lugnuts9 (at) MSN.com ---- '''Current Questions:''' *I would like to setup an ECU to go from High Z injectors to Low Z injectors if needed. Is this possible, and what is the best flyback setup. So far it looks like TS diode and resistors. But do I keep the diode and flyback board when running High Z? *Can I correct tuning functions based on EGT? *Can I O/P "high EGT" to an external warning light? *Can I correct tuning functions based on Fuel Pressure? *Is there a Vehicle Speed Input?(for boost control and launch) ---- Current Project: MembersPage/KevinBlack/VWPassatVR6 ---- '''Current Order, Project VW Passat VR6:''' * 1-wire interface: NO * Ignition driver: 4+4 * Knock and EGT: Yes (2 knock,1 EGT) * LCD and PS2: Yes * MAP connection: Onboard 250 or 400 KPA * PowerFlyback: High Z Injectors, do I need flyback? * Primary_trigger: VR (60-2 wheel) * Secondary_trigger: HALL (one window) * Lower (than 510 Ohm) resistors for i259 logiclevel outputs for use with VAG 1.8T COPs * OEM Bosch temp sensors (pullup needed?) ---- Note: you can check [http://tavi.sourceforge.net/FormattingRules formatting rules].
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.