####   
 #    #  
 #       
 #    #  
  ####   
         

           
     /\    
    /  \   
   / /\ \  
  / ____ \ 
 /_/    \_\
           
           

 _______ 
(  ____ \
| (    \/
| (_____ 
(_____  )
      ) |
/\____) |
\_______)
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

  _   _ 
 | \ | |
 |  \| |
 | . ` |
 | |\  |
 |_| \_|
        
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Kevin Black, Northeast USA. I am interested in helping develop the VEMS and selling to the VW/Audi market. Contact: Lugnuts9 (at) MSN.com ---- '''Current Questions:''' *Who and how do I contact about development,sales,etc. *What can be done to run Low-Z Injectors? *Can I correct tuning functions based on EGT? *Can I O/P "high egt" to an external warning light? *Can I correct tuning functions based on Fuel Pressure? *Is there a Vehicle Speed Input?(for boost control and launch) ---- '''Specifics/Desired Functions:''' *Motronic 60-2 crank trigger/VR sensor *Hall Effect Cam Sensor *NTC type Coolant and Air temp sensors *OEM MAP sensor (0-5v) *Throttle Options: 1)Standard 3 wire TPS 2)Audi AEB type throttle with internal IAC 3)DBW Throttle (back burner) *2 wire Push-Pull Stepper Idle Control Valve(see #2 and #3) *PWM Boost Control Solenoid *Sequential Injection, High-Z or Low-Z depending on target application. *Sequential Internal Ignitor COP Ignition *Tachometer Output (both 12v and high voltage for early cars) *Knock Sensors (2) *Bosch LSU 4.2 WBO2 (1) *EGT logging (1) *Fuel Pressure logging (0-5 volt linear sensor) ---- '''Shopping List:''' * 1-wire interface: NO * Ignition driver: 4+4 * Knock and EGT: Yes * LCD and PS2: Yes * MAP connection: Onboard 400 KPA or offboard, depending on target application. * PowerFlyback: Yes * Primary_trigger: VR (60-2 wheel) * Secondary_trigger: HALL (one window) * Lower (than 510 Ohm) resistors for i259 logiclevel outputs for use with VAG 1.8T COPs * Panel-mount EGT connector on endplate (instead of flying loom) ---- Note: you can check [http://tavi.sourceforge.net/FormattingRules formatting rules].
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.