###    
     #   
  ####   
 #   #   
  ### #  
         

           
     /\    
    /  \   
   / /\ \  
  / ____ \ 
 /_/    \_\
           
           

 ___   
(  _`\ 
| (_(_)
|  _)  
| |    
(_)    
       
       

 _______ 
(_____  )
     /'/'
   /'/'  
 /'/'___ 
(_______)
         
         

 #       
 #       
 # ###   
 ##   #  
 #    #  
 #    #  
 #    #  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Project VW Passat VR6''' *Demo/Test Vehicle for VEMS V3.3 *VW VR6 6 cylinder engine *Firing order 1-5-3-6-2-4 *Sequential fuel injection *60-2 VR crank trigger *1 Window hall cam trigger *NTC temp sensors *Standard TPS *2 OEM knock sensors *High-Z injectors *3X double ended waste spark coil with ignitor *2 wire PWM Bosch Idle Valve (min/closed duty ~25%) -Bosch #0 280 140 512/ VW #034 133 455B -2 wire, 8.2 Ohms (~1.5A) ---- TODO: *Scope idle valve,tach signal,injectors,ignition *Measure resistance curve of temp sensors *Install and configure v3.3 board ---- '''Current Order:''' * 1-wire interface: NO * Ignition driver: 4+4 * Knock and EGT: Yes (2 knock,1 EGT) * LCD and PS2: Yes * MAP connection: Onboard 400 kpa) * PowerFlyback: 30v bidr * Primary_trigger: VR (60-2 wheel) * Secondary_trigger: HALL (one window) * Lower (than 510 Ohm) resistors for i259 logiclevel outputs for use with VAG 1.8T COPs * OEM Bosch temp sensors (pullup needed?) ----
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.