___ 
 |_ _|
  | | 
  | | 
 |___|
      

  _______ 
 |__   __|
    | |   
    | |   
    | |   
    |_|   
          
          

         
### #### 
 ##  ##  
 ##  ##  
 ##  ##  
 ######  
     ##  
 #####   

         
  ####   
     ##  
  #####  
 ##  ##  
 ##  ##  
  ### ## 
         

  _   _ 
 | | | |
 | | | |
 | |_| |
  \___/ 
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
VW 2003 GTI 1.8t Project Page VAG 1.8t engine Late style 60-2 trigger wheel (flat surface with stamped holes instead of raised teeth) One window Cam Sync sensor from AEB 1.8t engine * VAG active COP coils ** ordered with 255 Ohm i259 output resistors for the logiclevel ign pins, good. Anyway, it's recommended to use stepper output to drive these VAG COPs, if stepper outputs are available. 400 KPA external MAP sensor 1x EGT sensor 1000cc/min Low-Z injectors 67mm turbo, T4 P-trim turbine wheel, .82 T3 turbine housing ---- '''ECU Order''' 1 x Assembled v3.3 controller - 1-wire interface: no - Flyback: 30V flyback - ignition driver: 4 - Knock and EGT: yes - LCD connection: yes - MAP connection: offboard(electronic) - mounting-style: no-screws - primary_trigger: VR - PS2 connection: no - secondary_trigger: HALL 1 x 3-4 bar MAP sensor 1 x Econoseal18-Wire side 1 x EconoSeal36-Wire side 1 x K-thermocouple connector - mounting-style: flying loom - Sex: female 1 x USB-Bluetooth 100m 1 x Wideband connector - With wire: without wires 1 x Wideband screw ----
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.