###      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
######   
         

_________
\__   __/
   ) (   
   | |   
   | |   
   | |   
___) (___
\_______/
         

  __  __ 
 |  \/  |
 | \  / |
 | |\/| |
 | |  | |
 |_|  |_|
         
         

   _____ 
  / ____|
 | (___  
  \___ \ 
  ____) |
 |_____/ 
         
         

         
     ##  
     ##  
  #####  
 ##  ##  
 ##  ##  
  #####  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Car: Nissan 240SX Engine: KA-24 4 cylinder Low-z Injectors, Honda resistor box 6.5 Ohm Hall trigger mounted in distributor, sensing a 4 window wheel. '''ECU #2168 (Order #3255)''' Car ran well every day for a week. '''Then, one day the Fan output(P259 Ch01) stuck ON, and later, it lost fuel Injector Ch 03 (Pin 20)''' '''I changed the fuel Injector to Ch04, and the Fan to P259 Ch6.''' '''I checked the GND5 connections, they measure 0.1 Ohm between them. Main Ground is 12 awg wire to engine block.''' '''I checked the Flyback wire. The Flyback wire is ran to the 12v input to the Honda resistor box. The resistor box has a common 12v supply, then branches out to the 4 injectors.''' '''Also, I added a wire from the Ignition output (IGBT 20) to the car's OEM Tachometer.''' '''Today, the ecu lost the Injector Ch04 driver''' I did three things at the same time to fix it (had no other choice, I do not have any spare FETs left!) - 1) Replace Honda resistor box (with another one that was in a running Honda, the box from the car was put into the running Honda and it is still running. 2) Replaced 20awg flyback wire with an 18awg flyback wire. The 20awg flyback wire was previously tested with a battery and a string of light bulbs. 3) The Honda resistor box had no connector, instead used ECxx terminal pins, pushed onto the resistor box terminals and strain relieved. This time we found the correct connector and installed it. '''I (thought) #3 was the problem.''' '''Last week, the ecu lost another FET.Again on cyl #2.''' '''I am going to replace the injector harness, I cannot think of anything else to do. Is it possible that these other FETS were compromised earlier, and the failure was bound to happen anyway?'''
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.