## ## ## ## #### ## ## ## ##
#### ## ## ## ## ## ## ####
##### ## ## ## ## ##### ## ##
### ## ## ## ## ## ##### ## #####
_ ( \ | ( | | | | | | | (____/\ (_______/
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: '''Cossi Triggerpage''' '''Primary tigger:''' *665 Ohm (with sensor disconnected) *148 mV (with sensor connected, ignition ON, not cranking) '''Secondary trigger:''' *817 Ohm (with sensor disconnected) *0 mV (with sensor connected, ignition ON, not cranking) ** NO pullup: might be very sensitive during cranking. 10..22kOhm pullup to +5V might help ***Tried, but nothing changed. The same result with 10-15-20kOhm pullup to +5V. We get good rpm values, but so far I can't adjust TDC with the ign_tdcdelay value. The LCD and Megatune shows the right RPM during cranking. When I try to positioning ign_tdcdelay, I get only erratic crank angle (measured by strobe) as I change the value (ign_crank_advance=01 ,crank advance 0.25 degree): *ign_tdcdelay=C8 (100 degree) the timing light shows ATDC 10 degree *ign_tdcdelay=A4 (82 degree) the timing light shows BTDC 70 degree *ign_tdcdelay=AA (85 degree) the timing light shows ATDC 2 degree It's looks OK, but if I use the right crank advance (8 degree under the crank),then get spark BTDC 70 degree again. I can't make spark between BTDC 70 degree and ATDC 2 degree. Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.