_   _ 
( ) ( )
| |/'/'
| , <  
| |\`\ 
(_) (_)
       
       

         
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

         
  #### # 
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
     ### 

 _______ 
(_____  )
     /'/'
   /'/'  
 /'/'___ 
(_______)
         
         

 #       
 #       
 #   #   
 #  #    
 # #     
 ## #    
 #   #   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Cossi Triggerpage''' '''Primary tigger:''' *665 Ohm (with sensor disconnected) *148 mV (with sensor connected, ignition ON, not cranking) '''Secondary trigger:''' *817 Ohm (with sensor disconnected) *0 mV (with sensor connected, ignition ON, not cranking) ** NO pullup: might be very sensitive during cranking. 10..22kOhm pullup to +5V might help The LCD and Megatune shows around the right RPM during cranking. When I try to positioning ign_tdcdelay, I get only 3 possibility erratic crank angle (measured by strobe) as I change the value: *BTDC around 80 degree *ATDC around 10 degree *ATDC around 100 degree
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.