____  
 | __ ) 
 |  _ \ 
 | |_) |
 |____/ 
        

         
         
 #####   
 ##  ##  
 ##      
 ##      
 ##      
         

         
 ##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
         

  _____  
 |  __ \ 
 | |__) |
 |  ___/ 
 | |     
 |_|     
         
         

         
         
  ####   
 #    #  
 #       
 #    #  
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Cossi Triggerpage''' Engine starts only with reverse crank sensor polarity. * reverse of the factory? * or reverse compared to what should be good ? **reverse of the right polarity, VR sensor signal is rising. ( in this case I won around 10 degree of advance) '''Primary tigger:''' *665 Ohm (with sensor disconnected) *148 mV (with sensor connected, ignition ON, not cranking) '''Secondary trigger:''' *817 Ohm (with sensor disconnected) *0 mV (with sensor connected, ignition ON, not cranking) ** NO pullup: might be very sensitive during cranking. 10..22kOhm pullup to +5V might help ***Tried, but nothing changed. The same result with 10-15-20kOhm pullup to +5V. We get good rpm values, but so far I can't adjust TDC with the ign_tdcdelay value. The LCD and Megatune shows the right RPM during cranking. When I try to positioning ign_tdcdelay, I get only erratic crank angle (measured by strobe) as I change the value: (ign_crank_advance=01 ,crank advance 0.25 degree) *ign_tdcdelay=C8 (100 degree) the timing light shows ATDC 10 degree *ign_tdcdelay=A4 (82 degree) the timing light shows BTDC 70 degree *ign_tdcdelay=AA (85 degree) the timing light shows ATDC 2 degree It's looks OK, but if I use the right crank advance (8 degree through the crank),then get spark BTDC 70 degree again. I can't make spark between BTDC 70 degree and ATDC 2 degree. ----- 2007-08-13 I do some measurement by scope with 15kOhm pullup to +5V on secondary trigger (both sensor conected with the right polarity) : [http://www.vems.hu/files/MembersPage/KarolyBakos/trigger/ign_on_no_crank.xls Ignition ON] [http://www.vems.hu/files/MembersPage/KarolyBakos/trigger/ign_on_cranking.xls Ignition ON & cranking] [http://www.metatron.hu/karesz/crank2.JPG Scope screenshot for detais]
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.