## # # # # # ###
###### ## ## ## ## ####
### ## ## ## #### ## ## ####
### ## ### ## ## ## ## ## ### ## ## ## ###
## ## ## ## ## ## #### ##
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: http://www.vems.hu/wiki/index.php?page=MembersPage%2FKamuto e92 drift car with vems and motec stuff + bmw s54 engine. vems v3 on bmw s54 with vanos done that no questions. motec c125 dash http://www.motec.com.au/c125/c125overview/ Communications 2 x Configurable CAN buses with individually programmable CAN bus speeds One can be used as RS232 Receive RS232: 2 x RS232 ports One with Transmit and Receive One with Receive only dash can be customised any way, both for can recieve and transmit, rs232 can be custom too as I understand motec PDM30 Communications 1 x CAN Has Outputs: 30 Inputs: 16 inputs can be used as switches for activating outputs from vems or simple switch. fuel pump, main relay. pdm can bus can be fully customized both ways. http://s9.postimg.org/ermjvce7j/pdm_can_bus.png http://s9.postimg.org/5xvne8r8v/pdm_can_bus1.png 1. the goal is to feed can bus to these 2 devices, to control fans, water pump, oil cooler fan, fans with pwm based on coolant temp and so on :) 2. feed Vems can bus data to C125 display, main parameters + oil pressure, fuel pressure, and oil temp is a must. the ways to do it?? aim2can? other hw? can id's m800 id 0x5f0 offset length divisor multipler rpm 0 2 6 wheelspeed oil pressure 24 2 oil temperature 22 2 water temp 8 2 1 battery voltage 44 2 throttle angle 2 2 1 manifold pressure 4 2 1 air charge temp 6 2 1 ex gas temp 32 2 1 10 lambda 10 2 1 fuel temp 18 2 fuel pressure 20 2 gear Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.