##   ## 
 ## # ## 
 ####### 
 ####### 
  ## ##  
         

 _   _ 
| | | |
| |_| |
|  _  |
| | | |
\_| |_/
       
       

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

         
         
  ####   
 ##      
 ##      
 ##      
  ####   
         

  _  __
 | |/ /
 | ' / 
 | . \ 
 |_|\_\
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
ecu repair history: '''ecu 9955''' 1: died installing, connected to it, made some changes and it died, impossible to connect. what was damaged? you say p259? '''ecu 10194''' 2: died after my failure with coil ground disconnected, started worked, and died slowly after I forgot to put coil ground cable in place after swapping ignition coils. baked one igbt, what more happened to it? thank you. update 2017/08/01 '''serial 15103''' battery voltage shows 0 after short when removing map sensor. '''serial 15104''' same as before, it's possible that solder blobs which makes path to rs232 are unsoldered. need gut replacement for those I believe 2 of those died because of me, some epic stupid mistake. shorted some pins on map sensor header when removing map sensor from it. some small trace of solder was left there, and now 5v regulator makes loads of heat. and I believe we have 14027 car died when guy was going out of petrol station, no signs of life after that and all cylinders full of petrol. need the same with 4 vr sensors on same pins, subaru trigger system. ---- 3 ECUs received are being rebuilt as gut replacement (even those that show some signs of life are abused enough so would be too risky to repair by replacing some chips). ---- 2018-06-14 ecu with tracking number CE711215409LT don't know serial number at the moment. ecu died when uploading configuration file, first it went to boot mode, after there was no more possible to connect to it, I have replaced rs232 chip in it, no luck. wiring adapter was done by some amateur electrician, i will check that later by myself. try to find what's wrong, if not possible to fix, replace the internals. thank you.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.