#  
      #  
  ### #  
 #   ##  
 #    #  
 #   ##  
  ### #  
         

___  ___
|  \/  |
| .  . |
| |\/| |
| |  | |
\_|  |_/
        
        

 __        __
 \ \      / /
  \ \ /\ / / 
   \ V  V /  
    \_/\_/   
             

         
 ### ### 
  ### ## 
  ##     
  ##     
  ##     
 ####    
         

         
|\     /|
( \   / )
 \ (_) / 
  ) _ (  
 / ( ) \ 
( /   \ )
|/     \|
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
My plan is to make the RadioBoard to be real, look also VemsFrontier/Bluetooth I got Volvo Amazon with B20. ---- What is currently working&tested firmware for older GenBoard/VerTwo? * the latest tested for v2 is very old, around 2004.11.24 * Now I got v11 firmware working on GenBoard/VerTwo somehow, it wasn't using h[] for inj (on GenBoard/VerTwo), problem was secondary trigger. Maybe I'll table test STABLE1_0 with GenBoard/VerTwo. Also few lcd pages are blank with v11, but I'll get back to this (testing new firware on v2). * I haven't used IAC with v2 but now I got bosch PWM controlled IAC in my hands. IAC takes ~1 amp, so L293 output (maybe 2 in parallel) would be good (should be fine, but make sure there is flyback diode and you disable stepper in config.stepper_conf). *** IAC stepper config bit disables pwm output at IDL output, so it disables digitalout() where I'll control the L293. But yes I'll disable stepper. *** There already are flyback if they are assembled, but did you mean that upper diodes should go to FLYBACK instead of +12v (+12v could be and in this case its fused)? Or is 1N4007 speed an issue, maybe not, but faster would be better (on injector flyback too)? * digitalout in firmware is not fully implemented when compiled to GenBoard/VerTwo. However it seems very easy to switch on/OFF any output at the end of injector.c digitalout() function based on the value of "facility" and "valbit". (valbit most significant, 7th bit is ON/OFF). ** Yes, that was very easy, thanks!
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.