####   
 ##  ##  
 ######  
 ##      
  #####  
         

 __          __
 \ \        / /
  \ \  /\  / / 
   \ \/  \/ /  
    \  /\  /   
     \/  \/    
               
               

 ___   
(  _`\ 
| ( (_)
| |  _ 
| (_( )
(____/'
       
       

         
         
 #####   
 ##  ##  
 ##      
 ##      
 ##      
         

         
         
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
QuickShifterSensorsTypes ||Mechanical force threshold adjustable switch: the switch activates when force threshold is exceeded||http://www.nmine.com/msavr/qs_forceswitch.gif|| ||It is similar than previous, but sensor is not a switch, it is a analog force sensor. Force threshold is usually configured by software. I also have seen a modified lever with strain gauges instaled for use with motocross and supermotard bikes.||http://www.nmine.com/msavr/qs_loadcell.gif|| ||It is the most simple method, it is a simple lever position microswitch, the cut happens when the shift shaft is in set-up position, Yoshimura quick shift sensor showed work in this way||http://www.nmine.com/msavr/qs_switch.gif|| ||It work like previous, but position is meassured by linear potenciometer and position is configured by software.||http://www.nmine.com/msavr/qs_pot.gif|| ::There are two ways to make quick shifter: ::*ignition cut- it ussualy make a ugly explosion in exhaust pipe. The only clean way involves fuelcut too. ::*retard spark- it is more elegant method. This is similar to ALS (anti-lag system) used in turbo engines (but not enough in itself, and involves much unnecessary heat) ::Both methods have delay under 0.1 seconds, typically 40 - 50 msec. Is this similar to ALS? (retard spark?) Or just event skipping? There is a redline RPM cut, which prevents RPM raising above a configured max. However some smart code to help RPM go to the natural next-gear RPM (it would be similar to idle-control, improved by adding event-skipping if it cannot go down further to reach target RPM just by closing the idlevalve).
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.