##  ##  
 ##  ##  
 ##  ##  
  #####  
    ##   
 ####    

         
         
  ### #  
 #   ##  
 #   ##  
  ### #  
      #  
  ####   

         
         
 # ###   
 ##   #  
 #       
 #       
 #       
         

         
         
  ###    
     #   
  ####   
 #   #   
  ### #  
         

         
         
 ##  ##  
  ####   
   ##    
  ####   
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I live in Gothenburg, Sweden and I'm mostly working on the VEMS hardware. I have been with the project from the start and I've had lots of previous user experience with competitor systems. MembersPage/JorgenKarlsson/TrackBMW My project car is an Audi 80 Quattro -83 with a 4.2l A8 V8 engine producing in excess of 300hp. This car still has the Autronic SMC engine management and use an MSD DIS-4 for ignition power. It has been running on that since well before the VEMS project was started. It will be upgraded to VEMS when the VEMS solution offer enough advantages over the current configuration. Two pictures of the car, last time I had it out of the garage. I have finally found bumpers for it now but have no pictures of it with them installed. http://www.vems.hu/files/MembersPage/JorgenKarlsson/DSCF0752_640.jpg http://www.vems.hu/files/MembersPage/JorgenKarlsson/DSCF0753_640.jpg ---- The car has passed inspection and is now mostly used to go get food when other cars are in the workshop. Today (2007-02-23) it was swapped over to E85 fuel and the cold start properties was tested in -5C, no problems at all with the MSD DIS-4 even if the car only got a few minutes of tuning after filling it up with E85 fuel. Q:Hi Jorgen,what mods were necceserry to run on E85 after pump gas?What lambda/(AFRs) are neededto run succesfully E85 (cruise,mid load,full load on turbo cars?) Was very nice to meet you personally :) Thank you//pnanassy Peter, I still aim at lambda=0.88 on ethanol. I have no experience from E85 in turbo cars but I have heard from several people that the engine doesn't loose power on rich mixtures like it does on petrol. On petrol I'm used to find that the power loss is almost linear from 0.88 to 0.82 or so and that it plumets somewhere around 0.78 or so. The stock fuelpump in this car is a bit small to supply enough fuel and I have found that the engine seem to loose more power on a lean mixture on E85 then it does on petrol. But this is only subjective for now, I will try to make some better measurements after fitting the 044. I think that many people run into trouble with dirt in old fuel lines when they switch to ethanol. So replacing hoses with new clean ones is probably a good idea, getting high quality hoses makes sense at this time. ---- Other projects and customer cars: MembersPage/JorgenKarlsson/LS1Trigger MembersPage/JorgenKarlsson/AudiAAN MembersPage/JorgenKarlsson/SimpleTrigger MembersPage/JorgenKarlsson/MercedesCossy MembersPage/JorgenKarlsson/PorscheTurbo MembersPage/JorgenKarlsson/AudiStwo MembersPage/JorgenKarlsson/RallyBMW MembersPage/JorgenKarlsson/TurboSeven MembersPage/JorgenKarlsson/TurboAlphaNCars MembersPage/JorgenKarlsson/KickStartEngine
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.