___   
(  _`\ 
| (_(_)
|  _)_ 
| (_( )
(____/'
       
       

 ___   
|  _`\ 
| (_) )
| ,  / 
| |\ \ 
(_) (_)
       
       

 __   __
 \ \ / /
  \ V / 
   > <  
  / . \ 
 /_/ \_\
        
        

  __  __ 
 |  \/  |
 | |\/| |
 | |  | |
 |_|  |_|
         

 __     __
 \ \   / /
  \ \_/ / 
   \   /  
    | |   
    |_|   
          
          

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I have had various problems with the new trigger error analysis on C004 cars. After the attention it has had over the last weeks I fear that this last problem may be a configuration issue. In any case the car runs fine. Car: Nissan 200 S14, custom harness. Primary trigger: Honeywell 1GT101 reading two teeth on the crank. Secondary trigger: Reading single slot in CAS with 24+1 wheel. Trigger used: C004 Error reported: Trigger error, Secondary position bad. Reported secondary trigger angle at idle(with reported error):85-95deg. http://www.vems.hu/files/MembersPage/JorgenKarlsson/C004_error/v3.3_n001400-A-2011.07.09-16.48.45_C004_testing.vemscfg When testing the same config on the bench the same error was reported and it remained the same when changing the trigger timing from 0-360 degrees. Only flickering one or two "less secondary trigg" when passing the primary trigger pulse.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.