___ 
 |_ _|
  | | 
  | | 
 |___|
      

 _     
| |    
| |    
| |    
| |____
\_____/
       
       

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
    ##   
 ####    

         
         
  ### ## 
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

         
### ###  
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  ### ## 
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I'm looking to build a VEMS controller for my S6. I know they are available built, but I would like to do it myself and I figure it will be a lot cheaper. I need to compile a parts list. 1 x Power Flyback 1 x 250-400 kPa MAP sensor 7 x Injector or WBO2 heater driver 5 x Ignition driver 1 x Idle stepper motor driver 1 x JPT55 connector 1 x Dual channel knock sensor interface 1 x Alubos gasket 1 x Alubos1600 1 x Alubos Endplate 1 x GenBoard v3.3 I also need a front plate for the JPT connector. Are any of these parts redundant? Are they already included in the GenBoard v3.3? Am I missing anything? Where can I find information on assembling the above parts? I have been looking at the wiki but don't find much yet.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.