###  
   ##    
  #####  
   ##    
   ##    
   ##    
         

         
     ##  
         
     ##  
     ##  
     ##  
     ##  
  ####   

         
         
 ######  
     #   
   ##    
  #      
 ######  
         

   ____  
  / __ \ 
 | |  | |
 | |  | |
 | |__| |
  \____/ 
         
         

         
         
 ######  
  ##  ## 
  ##     
  ##     
 ####    
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
As my Genboard v3.3 got wired up (see MembersPage/JoelZernask), this page is about the configration. ---- Here are the specs of my engine: * 1989 Audi PT 3,6 liter 32valve V8 * firing order: 1-5-4-8-6-3-7-2 * ignition type: wasted spark * coils: two 2*2 coil packs (Bosch 0 221 503 407) ---- Firmware version used: '''1.0.36''' Here is my config (manmcd command in Bray Terminal): http://pildid.audiclub.ee/joel/kuubik/config30112006.txt ---- '''Trigger''' '''Primary-VR''' * NOT multitooth * VR sensor (VR primary-trigger HW used; rising edge configured) * 4 trigger pins on the flywheel, 64 degrees BTDC each cyl ** each pulse 64 degrees BTDC (+/- 1 degree). '''Secondary-HALL''' * Disabled Problems faced with the trigger during the installation process are here: MembersPage/JoelZernask/TriggerPage (chronologically listed, lots of BS) ---- '''Ignition''' Cylinders firing together are: 1 5 4 8 6 3 7 2 The coil packs were planned to be connected as follows (PhatBob's guide): EC36-pin35 to Coil 1 EC36-pin33 to Coil 2 EC36-pin34 to Coil 3 EC36-pin36 to Coil 4 However, drives 00 (EC36-pin35) and 03 (EC36-pin36) appeared disfunctional (probably damaged) on my board, therefore had to be replaced. Now the cylinders are wired as follows: Cylinders 1 & 6 to Coil 1 to EC36-pin11 drive06 Cylinders 5 & 3 to Coil 2 to EC36-pin33 drive01 Cylinders 4 & 7 to Coil 3 to EC36-pin34 drive02 Cylinders 8 & 2 to Coil 4 to EC36-pin24 drive04 ---- '''Fuel''' Sequential fuel delivery for Audi 3,6 V8 PT engine firing order: 1-5-4-8-6-3-7-2 Bosch injectors 173cc Constant for RPM calculation is 1500. Req fuel is ca 16 (173cc injectors). ----
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.