_ _ ( ) _ ( ) | | ( ) | | | | | | | | | (_/ \_) | `\___x___/'
##### ## ## ## ## ##### ## ##
#### ## ## ## ## ## ## ####
## ## ##### ## ## ## ## ## ## #####
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: Hi my name is Joakim Røed. I`m a 28 year old car mechanic from Norway. I mainly work with MB light transporter vehicles such as the Vito and Sprinter. I have no programming or electronic design skills, but I do know how to swing my soldier iron:) ----------------------------------------------------------------- Car: 73 AMC hornet hatchback. Engine: +030 AMC 360 with TRW 8.5:1 powerforged pistons. Camshaft specs: Intake/exhaust dur.@050 - 224/234. Valve lift - 0.496/0.521" Lobe separation - 114degrees, hydraulic. Torker intake drilled for 8 injectors. 80mm BBK throttle-body. Home made turbo headers, 50mm wastegate, Holset HX55 turbocharger(67mm inducer), Air to water IC. Fuel system: Fuel-cell, Magna Fuel Prostar EFI pump, 10AN feed line and 8AN return with cooler, 8 Bosch 160lb/hr injectors(low Z), Aeromotive fuelpressure regulator, Universal Holley fuelrails. ----------------------------------------------------------------- I want to run sequential injection and COP distributorless ignition. At first I wanted to use the B&G megasquirt together with my MSD pro-billet dizzy and Digital6+ box, but I was told the idle would be very rough with batchfire injection and 160lb/hr injectors. So I searched the net for other options and ended up ordering a Genboard/V3.1:) ----------------------------------------------------------------- Q`s and A`s: Q: is this the right positions for ignition IGBT`s and the MAP-sensor?: http://drumpounders.com/hornet/Bilde008.jpg A: The map sensor needs to be mounted like this: [http://www.vems.hu/files/DaveBrul/ctiturbo%20(103).jpg map pic#1] [http://www.vems.hu/files/DaveBrul/ctiturbo%20(104).jpg map pic#2] I used a ic-foot piece to raise the map sensor a bit, that way mouting the hose to it is easier. The orientation of the FETS and IGBTS is good - DB ---------------------------------------------------------------- Updates: 15.08-04 I have recieved my Genboard/V3.1 (board #71) and soldierd on the ecnoseal connectors, injector and WB FET`s. Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.