#####  
 ##      
  ####   
     ##  
 #####   
         

    ##   
   #  #  
   #     
 #####   
   #     
   #     
   #     
         

         
    ###  
   ##    
  #####  
   ##    
   ##    
   ##    
         

         
         
  #####  
 ##      
  #####  
      ## 
 ######  
         

         
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I'm planning to replace existing old Haltech ECU with Genboard v3.2 for my loved 85Alfa Romeo GTV6. I'm looking for good references to instruct me to assemble v3.2. Can any one Help? Maybe this will help? http://vems.hu/www.vems.co.uk/VEMS I'm sure many people will help. It takes little to assemble, but there are many customizations possible to connect and configure. The only necessary condition is to describe what you need and what is available. * Make an index page * and 6..15 pages for your project, nicely split thematically * make it clear what is solved/how and what is yet to be found,bought,solved with each subproject * start with these docs, some of it is needed even at the BOM phase (list of things to buy) Much of the Haltech wiring will map nicely to the v3.2. The customizations required will depend on your current setup. Start by documenting your wiring and ECU pinout, injection type, trigger method, sensors, controls, etc, and people can assist you from there! Good luck!
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.