##    
         
  ###    
   ##    
   ##    
   ##    
  ####   
         

         
         
 ##  ##  
  ####   
   ##    
  ####   
 ##  ##  
         

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

         
         
  #####  
 #       
  ####   
      #  
 #####   
         

 _____ 
(_   _)
  | |  
  | |  
  | |  
  (_)  
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Switching to Genboard on my Golf racer, because K-Jet isn't cutting it. Later on I will be doing forced induction, so I need room for change. Pictures and some info: http://proton.shadowflux.com/vwracing/ email james at shadowflux dot com ---- Progress report (Nov 11): Firmware r023 Starts and runs! Idles fairly smoothly with only set-screw holding throttle body at 4-5% open. Drove around a little bit, runs very well and all parameters look good. Accelerates much harder than when K-Jet was running the show, until it gets to the sections of fuel map I haven't tuned. I'll be reviewing logs today, updating tables and doing more testing, provided the rain stays away. Thank you, everyone, for your help! * Notes: * * VE table values had to be doubled even though req_fuel was set at value recommended by req_fuel calculators. * * Top dead center after trigger was retarded by 30 crank degrees. * * Use MegaTune to enable/disable features (misc_out, boost control, iac, etc). Disable values in config.txt inconsistent between feature channel outputs. * * LCD display is cutting out, displaying with strange offsets, otherwise acting funny. Vibration getting to headers or wiring elsewhere? Will test. ---- Config Latest/revised comments config: MembersPage/JimW/Config Notes about subsystems (to verify/justify config variables) on pages below * MembersPage/JimW/FuelSystem * MembersPage/JimW/InputTrigger * MembersPage/JimW/IgnitionOutput * MembersPage/JimW/AirFeed * MembersPage/JimW/Wiring * MembersPage/JimW/Sensors ---- My Genboard and LCD display: http://proton.shadowflux.com/vems/genboard_32_1.jpg http://proton.shadowflux.com/vems/lcd_box_1.jpg http://proton.shadowflux.com/vems/lcd_box_2.jpg ----
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.