##  
     ##  
  #####  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

 ###     
  ##     
  ##  ## 
  ## ##  
  ####   
  ## ##  
  ##  ## 
         

         
         
  ####   
 ##  ##  
 ######  
 ##      
  #####  
         

  _    _ 
 | |  | |
 | |__| |
 |  __  |
 | |  | |
 |_|  |_|
         
         

         
 ##      
 ##      
 ## ##   
 ####    
 ## ##   
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
--- Old WBO2 sensor calibration issues, may help someone troubleshoot problems: Intermediate nernst_dc_target values resulted in wavering (by about 0.2V, instead of the max 0.1V allowed maximum) Nernst voltage. When nernst_dc_target was raised to 0xBD, Nernst voltage was dead steady at 4.47v (maybe pump was railed at max FF?). WBO2 testing page says I need '''3.96V+0.45V=4.41V''' sortof steady, so lowered nernst_dc_target to 0xB7, but voltage started to waver again. With values where Nernst voltage wavers, pump value (on mlp07 of LCD) is a value such as 0xC3, jumps to FF briefly, then back down to 0xC3 (0xC3 is just an arbitrary number. actual value is above 0xC0, but I don't remember what it was). When measuring nernst and pump-, I have varying values. I think the values i measured were bouncing between 120mv and 150mv. They are written down at home, I will post later. I changed wbo2_pump_pidki from 0x40 to 0x20, but didn't see a difference in voltage values. Should this affect the bouncing of voltage up and down when measuring nernst (to ground) voltage and nernst to pump- voltage? yes, it sounds like a WBO2 PID configuration issue (oscillation), because your WBO2 pump (HW) seems to react. Play with the values, especially pump_pid.... eg. try this: * wbo2_pump_pid_kp=30 * wbo2_pump_pid_ki=80 * wbo2_pump_pid_kd=00 * wbo2_pump_pid_ilimit=80 Above suggested settings work well so far. Only had to adjust the wbo2_calibration and bring nernst_dc_target back down to reasonable values.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.