##  ##  
 ##  ##  
 ######  
 ######  
 ##  ##  
         

         
         
  ####   
 ##  ##  
 ######  
 ##      
  ####   
         

         
         
 ######  
    ##   
   ##    
  ##     
 ######  
         

     ##  
         
    ###  
     ##  
     ##  
 ##  ##  
 ##  ##  
  ####   

         
     ##  
         
     ##  
     ##  
     ##  
     ##  
  ####   

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Honda delSol (92-95 CRX) install documentation: Most of this applies to any 1992-1995 US Civic or Integra Car: 1993 delSol "S" model B18B non-VTEC from 1994 Integra LS Coil on plug from Ford F150 Stock distributor retained only for VR sensors *Excerpt from the Honda Factory manual: "The CRANK sendor determines timing for fuel injection and ignition of each cylinder and also detects engine RPM. The TDC sensor determines ignition timing at start-up (cranking) and when crank angle is abnormal. The CYL sensor detects the position of No. 1 cylinder for sequential fuel injection to each cylinder." Stock ECU pinout: ||A1 - INJ1||EC36-7|| ||A2 - INJ4||EC36-20|| ||A3 - INJ2||EC36-19|| ||A4 - VTEC Solenoid (if equipped)|| || ||A5 - INJ3||EC36-8|| ||A6 - O2 Heater Control||(Wideband replaces this)|| ||A9 - Idle Air Control||EC36-3|| ||A12 - Cooling Fan||EC36- || ||A13 - Check Engine Light||N/A|| ||A15 - A/C Clutch|| || ||A16 - Alternator|| || ||A17 - Air Bypass Solenoid (GSR Engine)|| || ||A20 - Evap Purge Control Solenoid|| || ||A21 - Ignition Signal (input to coil)||EC36-34|| ||A23,24 - GND||EC36-26|| ||A25 - Switched +12||EC36-25|| ||A26 - AGND||EC36-5|| || || || ||B1 - Switched +12|| || ||B2 - AGND||EC36-21|| ||B5 - A/C Pressure Switch|| || ||B9 - Constant power|| || ||B10 - Vehicle Speed Sensor|| || ||B11 - Cyl position sensor +|| || ||B12 - Cyl position sensor -|| || ||B13 - TDC sensor +||EC36-13|| ||B14 - TDC sensor -||EC36-32|| ||B15 - Crank position sensor +||EC36-27|| ||B16 - Crank position sensor -||EC36-32|| || || || ||D1 - Constant Power|| || ||D2 - Brake Switch|| || ||D3 - Knock Sensor||Seperate Header on Board|| ||D4 - Service Check Connector|| || ||D6 - VTEC Pressure Switch|| || ||D7 - TX/RX Data Link Connector|| || ||D9 - Alternator|| || ||D10 - Electrical Load Detector (USA Only)|| || ||D11 - TPS Sensor||EC36-1|| ||D13 - CLT (Coolant Temp)||EC36-14|| ||D14 - O2 Sensor signal||Unused with Wideband|| ||D15 - Intake Air Temp||EC36-2|| ||D17 - MAP sensor||on-board|| ||D19 - +5V for Sensors (MAP)||unused|| ||D20 - +5V for Sensors (TPS)||to TPS|| ||D21 - GND for Sensors (MAP)||unused|| ||D22 - GND for Sensors (TPS, CLT, IAC, O2)||EC36-32||
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.