______  
(  __  \ 
| (  \  )
| |   ) |
| |   | |
| |   ) |
| (__/  )
(______/ 
         

         
         
  ####   
     ##  
  #####  
 ##  ##  
  #####  
         

         
 ##      
 ##      
 ## ##   
 ####    
 ## ##   
 ##  ##  
         

 _______ 
(  ___  )
| (   ) |
| |   | |
| |   | |
| |   | |
| (___) |
(_______)
         

         
  #### # 
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
     ### 

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
[MembersPage/JanSaenen] Current state: Used MembersPage/PhatBob/UserGuide and Firmware .38 I'm using a BMW M20 6 cylinder engine simular to MembersPage/GergelyLezsak It uses the following sensors and injectors: *440CC injectors Bosch *Stock single coil distributer *VEMS Internal Map sensor (working) *VEMS shop IAT sensor (working) *WB02 5057 sensor (working) *Other CLT sensor (working) *Volvo TPS sensor (working) *Stock VR sensor (working) ---- ''''07-06-06'''' I've connected the ICV, fuelpump and cleaned up some wiring. It's running now but seems to have some trigger errors. Rpm is jumping between 30 and 3000. I'll get to that this friday. If that's fixed I'll try to get it running at idle. ---- ''''29-05-06'''' It runs but I still haven't connected the ICV. It's realy rich according to lambda readings but it's nice to hear it run again. I still have to check all readings because I don't trust them jet. Hopefully I'll have time to do that next. *Connect ICV which I don't know how to do that *Connect the fuelpump *Tune the settings and get it to run at idle ---- '''IAT and CLT:''' [/MembersPage/JanSaenen/Tempsens] ---- ''''Fuelpump'''' [/MembersPage/JanSaenen/Fuelpump]
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.