##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

###      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
######   
         

         
 ##      
 ##      
 ## ##   
 ####    
 ## ##   
 ##  ##  
         

______ 
| ___ \
| |_/ /
|    / 
| |\ \ 
\_| \_|
       
       

   ____ 
  / ___|
 | |    
 | |___ 
  \____|
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I put EC36pin15 to my fuelpump relay. I tested it, with manual power switched to it. This worked and the fuelpump was running. Now I have to configure the AVR to run it. In "Extra\Waterpump, Fan, Fuel pump" I set the following parameters: *Pump on afterpowerup 3.2 *Pump on after inactivity 2.2 Now I need to chose a Fuelpump Driver and Channel. GenBoard/Manual/DigitalOut/Table suggests EC36pin15 is P259 channel 5. If you don't have '''any''' output configured to this channel, you can manually switch it on / off with ''mdhd7'' / ''mdh57'' menucommands (to test it). Select P259 channel 5 (not i5, as that will invert the output!) in megatune or apply <code> fuelpump_channel=57 </code> in your etc/config.txt ---- ''''9 April 2006'''' I've tried the instructions above but no activity is measured at EC36pin15. *I've applied fuelpump_channel=57. This resulted in megatune parameters set as: P259 channel 3!!?? *I've changed the megatune settings in P259 channel 5. Notting happend. *When I manualy put power on the wire to EC36pin15 the pump works and the car runs. **You mean manually ground the wire right? Your wording suggests you are hoping vems applies 12v to the relay. Is my genboard not working or are there any other faillures that can cause this malfunction?? *And again I learned something new about Vems :) Thank you very much. I indeed thoughed Vems would apply 12v to the relay. I could have known this. Thank you very much!
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.