#       
 #       
 # ###   
 ##   #  
 #    #  
 #    #  
 #    #  
         

         
 ##      
 ##      
 ## ##   
 ####    
 ## ##   
 ##  ##  
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

         
         
 ##  ##  
  ####   
   ##    
  ####   
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I put EC36pin15 to my fuelpump relay. I tested it, with manual power switched to it. This worked and the fuelpump was running. Now I have to configure the AVR to run it. In "Extra\Waterpump, Fan, Fuel pump" I set the following parameters: *Pump on afterpowerup 3.2 *Pump on after inactivity 2.2 Now I need to chose a Fuelpump Driver and Channel. GenBoard/Manual/DigitalOut/Table suggests EC36pin15 is P259 channel 5. If you don't have '''any''' output configured to this channel, you can manually switch it on / off with ''mdhd7'' / ''mdh57'' menucommands (to test it). Select P259 channel 5 (not i5, as that will invert the output!) in megatune or apply <code> fuelpump_channel=57 </code> in your etc/config.txt
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.