_________
\__    _/
   )  (  
   |  |  
   |  |  
   |  |  
|\_)  )  
(____/   
         

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

         
         
 # ###   
 ##   #  
 #       
 #       
 #       
         

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
     ##  

   _____ 
  / ____|
 | |     
 | |     
 | |____ 
  \_____|
         
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''5cyl 20VT audi for drag racing''' Engine is built to >800 Hp specs. A similar engine measured on engine dyno reached: 976 Hp at 375kPa @ 8000 RPM. We'll see. ---- '''Trigger''' 10+1 trigger, that is * primary trigger: HALL 5 pulses on crank ** trigger_tooth=01 is appr 72 deg BTDC (trigger_tooth=00 would be at about TDC prev cyl, not good) * secondary trigger: HALL 1 pulse on cam See InputTrigger/MultiToothNoneMissing Engine is running with firmware 1.1.27 http://www.vems.hu/download/v3/ * V3GUI_ ... firm1.1.27 ** but firmware and temp tables are uploaded already, should NOT be needed * VemsMT1.1.27 prebta0 ** use to tune maps (12x12 highboost). Don't tweak trigger settings with it. ---- '''Injectors''' Now running with small injectors (from some Opel Monsa), 1000cc/min low-impedance injectors will be used with 6.8 Ohm (50W) series resistors. ---- '''Ignition''' Now running with inductive ignition. (idles at 77kPa, around 800 RPM, big cams) It sounds like not all 5 cyls run at idle. (gets better at rev) * proper sparkpulgs will be installed * with the 5 big coils, dwell can be set higher, to 4.5 or even 5 msec. Finally it will use CDI ignition.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.